Cloverleaf Heater Digital Stainless 1kw

The Cloverleaf Heaters come with rigid or flexible pipe connections and are very simple to install into new or existing pond configurations.

Using the two hosetails provided, you can connect using a 19mm, 25mm, 32mm, or 38mm flexible pond hose. Alternatively, the units will also accept a 40mm stiff solvent weld or a 1.5-12 rigid pressure pipe.
These straightforward, simple to use pond heaters offer a safety low flow cut off button for peace of mind with a minimum flow rate of 4000 lph.

The pond should be covered and insulated for best efficiency and to maintain an ambient temperature. If there is insufficient insulation, additional KW per gal/litre may be needed, depending on the degree of desired water temperature.

There are two models: a 1Kw model for ponds up to 1000 gallons (4500 lts) and a 2Kw model for ponds up to 2000 gallons (9000lts).

4000 lph minimum flow rate and 1 and 2 kw power consumption specifications
1.5m cut end cable with thermostatically regulated IP55 rating installed
Solvent weld inlet and outlet along with flex hosetails measuring 230 cm, 18.5 cm, and 18.5 cm

You recently viewed

Clear recently viewed